Promag CON-485 Series Operations Instructions download pdf (Page 69)

Memo-Graph S 7 Procedure in operation

Endress+Hauser 69

7 Procedure in operation

Version with die-cast front : Version with stainless steel front:

Figure 7: Version with die-cast front and version with stainless steel front

1 Colour screen

2 Function LEDs

3Drive doors

4 Socket for front-mounted RS 232 operating interface (only for IP54 die-cast front)

5 ATA flash memory card

6Eject button for ATA flash memory card

7 Write LED for ATA flash

8 Operating keys / Softkeys

Note!

On the version with “IP 65 stainless steel front”, the ATA flash memory card drive can be accessed

from the rear. Doors and front-mounted RS 232 operating interface do not apply.

Function keys/Softkeys in normal operation

The function of the operating keys is described in the fields directly above the corresponding keys

on the screen.

– Empty fields mean that the corresponding key currently has no function.

– When you are operating the device, the measured value acquisition / limit value monitor, etc.

continue to run without interruption.

1. Press the corresponding key.

2. Make your selection with the following keys:

–“↑” or “↓”: selects/changes parameters

–“↵”: confirms the selection

–“←” or “→”: moves cursor

– “ESC”: cancels the last operating step or returns to previous screen

Note!

Any values that are displayed in grey can not be selected / can not be changed (only notes, or option

not available/not activated).

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 97 98

No comments

Promag CON-485 Series Operations Instructions Page 69